S-Video is a video format that has recently become popular on TV monitors and VCRs. If you don’t
have either of these types of video formats available, you can use the regular Video input on your TV or
VCR to display the composite video output.
Once you have all the Peripherals attached, power-up the S-760 while holding down the Mode button,
this will take you to the Setup Menu. Move the LCD cursor with Cursor up and down buttons to 3.
Controller and use the Value knob to select Mouse+CRT, or RC-100+CRT, depending on which exter-
nal controller you wish to use with the S-760. After changing the parameters on the Setup Mode, press
the Exit button, and the S-760 will display “EEPRM Renewing.....” and the S-760 will come to the
Performance Play Page 1 on your external monitor, the LCD display will show “>>Please See Your
CRT<<”. At this point you should be able to move your mouse and see the cursor move across the
screen. If you are using a RC-100, and the cursor does not move when you move the mouse, press the
reset button on the back of the RC-100. The lights on the RC-100 will scan and the mouse should now
become active.
AA
QQuuiicckk
ttoouurr
ooff
tthhee
SS--776600
wwiitthh
aa
MMoouussee
aanndd
CCRRTT
After following the previous instructions, all of the S-760’s operations can now by accessed by your
mouse and monitor.
As you can see when first booting the S-760, you come to the Performance Play Page 1, which displays
all of the Mode Menu Switches at the top of the screen.
If you move your mouse cursor to the Performance, Patch, Partial, Sample and Disk mode menu switch-
es at the top of the page and click with the mouse button on the mode name, you will be given a list of
functions to select in that particular mode. This makes it easy to change modes quickly.
On the line below the Mode Menu Switches, you’ll see the Mark, Jump and Command switches on the
right of the screen.
By clicking the Mark switch with your mouse, you can set-up a marker on any one of twenty different
locations on the list that is displayed.
This menu allows you to select the pages you use most often. To exit this mode, click on the blue
screen outside of the Mark dialog box and then click on the Jump switch next to the Mark switch. Here,
you can see the same list that you saw in the Mark box.
Click on the second marked page “ Disk Load”. The S-760 display will now show the Disk Load page.
To get back to the Performance Play Page, click on the Jump switch again and select the first marked
page “Perform Play 1”, and you’ll be back to where you started.
The Command switch to the right of the Jump switch, is where you go to use commands within a Mode.
Click on the Command switch and you will see the commands available within the Performance mode.
© 1995 Roland Corporation U.S. SN29 S-760 Supplemental Manual Page 12 of 17
To Next Page
Loading...
