Before using the KD-120, you need to follow the steps below to make the appropriate
settings for the TD-10.
However, these settings won't be necessary if your TD-10 has been upgraded by means
of the TDW-1.
Should you neglect to make the appropriate settings for the TD-10, you could likely experience the
following problems:
• Sometimes the kick drum does not sound (uneven volume)
• The volume of kick drum is too small (reduced sensitivity)
Procedure
* Do not strike any pads or step on any pedals (except the KD-120) until the following settings are complete.
1. Press the [SETUP] button.
The “SETUP MENU” screen appears.
2. Press the [F1 (TRIG)] button.
The “TRIGGER BASIC” screen appears.
3. Use the [TRIG SELECT] buttons to select the pad being used
for the kick.
The upper right of the display will show “H1 [KICK]”.
4. Use the [CURSOR] buttons and [VALUE] dial to modify the
values of the settings so they match those in the screen
depicted at right.
5. Press the [F1 (BANK)] button.
The “TRIGGER BANK” screen appears.
6. Using the [CURSOR] buttons and [VALUE] dial, change the
setting so it matches that shown at right (K 2).
7. Press the [F3 (ADVNCD)] button.
The “TRIGGER ADVANCED” screen appears.
8. Use the [CURSOR] buttons and [VALUE] dial to modify the
values of the settings so they match those shown at right.
This completes the settings you need to make for the TD-10.
For KD-120 and
Non-Expanded TD-10 Owners
40343345 ’03-6-3N
To Next Page
Loading...
Need help?
General
