Roland VS-1680 - Page 4

®ÂØÒÅÎ Supplemental Notes VS-1680 Frequently Asked Questions
process. If you havent already, you will need to mix
your songs down to a two track stereo format. You can
do this by recording to an external device such as a
DAT machine or cassette deck or by bouncing your
tracks down to a stereo pair within the VS-1680 itself.
If you are unsure of the procedure for bouncing tracks,
refer to section IX on page 11.
How Do I Choose Which Tracks are Burned to the CD?
CDs are a stereo format. This means that you will
always designate two tracks (left and right) to be
burned onto the CD-R. Use the following procedure to
designate a left and right track for creating a CD:
1) Hold SHIFTand press F1 [SONG] and
the Song Menu screen will be dis-
played. If it is not, press F6 [EXIT].
2) Press PAGE until CD WT appears
above F3.
3) Press F3 [CD WT] to display the CD
Write Ready? screen.
4) Press YES and Store Current? will
be displayed. If you have made any
changes to your song that have not
been saved, press YES;otherwise,
press NO.
5) Press F1 [SelTr] to display the
Select Track screen (Fig. 3).
6) Use the TIME/VALUE dial to select the track (and
Virtual Track) that will become the left side of the
CD and press F3 [Sel L]. For example, if your stereo
mix is recorded to Tracks 15 and 16, you will high-
light 15-1: V.T 15-1 and press F3 [Sel L] to desig-
nate Track 15 (V-Track 1) as the left track of the CD.
7) Use the TIME/VALUE dial to select the track (and
Virtual Track) that will become the right side of the
CD and press F4 [Sel R].
8) Press F1 [Back] and the tracks you selected will be
displayed under L-Ch Source Track and R-Ch
Source Track. You can now continue with the CD
Write procedure on page 121 of the VS-1680
Owners Manual.
1998 Roland Corporation U.S. VS-1680 Frequently Asked Questions Faxback # 21067 Page 4
How Do I Burn Audio CDs? (continued)
FFiigg.. 33 CCDD--RR TTrraacckk SSeelleecctt SSccrreeeenn