Roland VS-1680 - Test Mode Operations; Entering and Exiting Test Mode; Test Menu Navigation; LCD and LED Diagnostics

®ÂØÒÅÎ Supplemental Notes VS-1680 Frequently Asked Questions
3) Press F1 and Init Mix/Sys Prm Sure? will be dis-
played.
4) Press YES and Initializing...Please Wait will be dis-
played.
5) Press PLAY/DISPLAY to return to the main play screen.
The VS-1680 allows you to create a tempo map
that controls tempo and meter changes throughout
your song. This is very convenient when you are
integrating the VS-1680 with a MIDI sequencer.
Use the following procedure to create a Tempo
Map.
1) Hold SHIFT and press F5 [SYSTEM] and
System Menu page should be displayed.
If it is not, press F6 [EXIT].
2) Press F6 [SYNC]. If SYNC does not appear above
F6, press PAGE followed by F6. The Sync/Tempo
page should be displayed (Fig. 4).
3) Press F3 [Tmap] to display the Tempo Map screen
(Fig. 5).
4) CURSOR down to the current tempo setting
(e.g.
q=120) and use the TIME/VALUE dial to
select the desired starting tempo for your song.
5) CURSOR down to the beat setting (e.g. 4/4) and use
the TIME/VALUE dial to select the desired time
signature.
6) Press F2 [NEW].
7) Use the CURSOR buttons to highlight the
tempo setting and the TIME/VALUE dial to
select the new tempo.
8) CURSOR down to the measure setting and use
the TIME/VALUE dial to select the measure
where you want the new tempo to begin.
9) CURSOR down to the beat setting (e.g. 4/4) and use
the TIME/VALUE dial to select the desired time signa-
ture.
10) Repeat steps 6-9 for any additional tempo and/or
time signature changes as desired.
FFiigg.. 55 TThhee TTeemmppoo MMaapp
DDiissppllaayy
1998 Roland Corporation U.S. VS-1680 Frequently Asked Questions Faxback # 21067 Page 7
Restoring the Mixer Parameters to the Factory
Settings (continued)
FFiigg.. 44 TThhee SSyynncc//TTeemmppoo
DDiissppllaayy
TTeemmppoo MMaapp ##11 mmuusstt aallwwaayyss ssttaarrtt aatt mmeeaassuurree
oonnee..
VI. How Do I Create a Tempo Map?