Roland VS-1680 - Page 6

®ÂØÒÅÎ Supplemental Notes VS-1680 Frequently Asked Questions
3) Press the TRACK SELECT button for the track
selected as the L-Ch Source Track so that the
Track Mixer screen is displayed.
4) Use the CURSOR buttons to highlight the Link
parameter and use the TIME/VALUE dial to select On.
5) Use the CURSOR buttons to highlight Pan
parameter (under the pan knob icon) and use the
TIME/VALUE dial to select 0.
6) Use the CURSOR buttons to highlight the EQ Sw
parameter and use the TIME/VALUE dial to select Off.
7) Use the CURSOR buttons to highlight the EFX 1
parameter and use the TIME/VALUE dial to select
Off. Do the same for EFX 2, 3, and 4.
8) Use the CURSOR buttons to highlight the EFX Ins
parameter and press YES. Use the TIME/VALUE dial
to select Off for EFX 1. Do the same for EFX 2, 3,
and 4.
9) Use the CURSOR buttons to highlight the ATT
parameter and use the TIME/VALUE dial to select 0dB.
10) Press AUTOMIX so it is not lit.
11) Press the TRACK STATUS button for the track
selected as the L-Ch Source Track until it is in
Play mode (green) and set its fader to 0dB. Bring the
remaining channel faders all the way down.
12) Set the master fader to 0dB. Reset your song to the
beginning and press PLAY to hear your song as it
will sound on the CD.
The VS-1680 gives you the ability to revert all your
mixer and system parameters back to their original fac-
tory settings. This is convenient if you want to reset the
mixer and system settings to their original values with-
out having to adjust each parameter manually. This is
also a good function for troubleshooting when you hav-
ing difficulties that appear to be mixer related. Use the
following procedure to initialize the VS-1680 mixer and
system parameters:
1) Hold SHIFT and press F5 [SYSTEM] and the
System Menu page should be displayed. If it is
not, press F6 [EXIT].
2) Press PAGE so that INIT is displayed above F1 (if
necessary).
1998 Roland Corporation U.S. VS-1680 Frequently Asked Questions Faxback # 21067 Page 6
Listening to a Song Before Burning the CD (continued)
V. How Do I Restore the Mixer Parameters to the
Factory Settings?