Roland VS-2000 - Page 34

34
Algorithm List
Analog Phaser
Two units of analog phasers are placed in parallel to accommodate stereo sounds. Surges unique to Phaser is created by adding
sounds with the phase shifted periodically.
fig.08-75
Parameter (full name) Setting Function
APH (Analog Phaser): Two units of analog phaser are placed in parallel to accommodate stereo sounds.
Sw (Switch) On, Off Turns the analog phaser on or off.
Mode (Mode) 8STAGE, 4STAGE Sets the number of stages of phaser.
Freq (Frequency) 0–100 Sets the center frequency to which the phase effect is applied.
Reso (Resonance) 0–100 Enhances frequency components at around the center frequency set with Frequency.
LFO1/2 Rate (LFO1/2 Rate) 0–100 Sets the phase effect cycle length.
LFO1/2 Dep (LFO1/2 Depth) 0–100 Sets the depth of the phase effect cycle.
LFO1/2 ChB
(LFO1/2 Channel B Inverse )Nor Inv “Inv” indicates that the surge phase should be inverted and “Nor” indicates that it should not be
inverted.
Analog
Phaser L
Analog
Phaser R
Input L
Input R
Output L
Output R
Number of stages of Phaser
As the number of sages of Phaser increases, the number of frequency points suppressed increases as well, generating sharper
effect.
fig.08-76e
Frequency
Level
Frequency
Level
4 stage
8 stage
VS-2000_e.book 34 ページ ２００５年１２月１２日 月曜日 午後４時５４分