EasyManua.ls Logo

Roland VS-2000 - Page 42

Roland VS-2000
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
42
Algorithm List
Guitar Amp Modeling (Guitar Amplifier Modeling)
Models a guitar amplifier.
fig.08-34
Parameter (full name) Setting Function
NS (Noise Suppressor): Mutes noise in the silent mode.
Sw (Switch) On, Off Turns the noise suppressor on or off.
Thresh (Threshold) 0–100 Sets the level to start muting noise.
Release (Release) 0–100 Sets the time over which the volume will drop to 0 after the noise starts being muted.
AMP (Pre-Amplifier): Models the pre-amplifier section of a guitar amplifier.
Sw (Switch) On, Off Turns the compressor on or off.
Amp Type (Pre-amplifier type) See the column on
the next page. Sets the type of the guitar amplifier.
Gain (Gain) Low, Middle, High Sets the degree of sound distortion on the pre-amplifier.
Bright (Bright) On, Off
You can set this on to generate clear-cut bright sounds.
*1
Volume (Volume) 0–100 Sets the volume and degree of distortion of the amplifier.
Bass (Bass) 0–100 Sets the tone of the low range.
Middle (Middle) 0–100 Sets the tone of the middle range. *2
Treble (Treble) 0–100 Sets the tone of the High range.
Presence (Presence) 0–100 (-100–0) Sets the tone of the ultra-High range. *3
Master (Master) 0–100 Sets the volume of the entire pre-amplifier
Sp (Speaker Simulator): Models a speaker.
Sw (Switch) On, Off Turns the speaker simulator on or off.
Sp Type (Speaker Type) See the column on
the previous page. Sets the speaker type.
Mic Setting (Microphone Setting) 1, 2, 3 Sets the location of the microphone that is recording the sound of the speaker.This can be adjusted
in three steps, with the microphone becoming more distant in the order of 1, 2, and 3.
MicLvl (Microphone Level) 0–100 Sets the microphone volume.
DirLvl (Direct Level) 0–100 Sets the volume of the direct sound.
*1: Can be set only when JC-120, Clean Twin or BG Lead is selected for Pre-amplifier Type.
*2: Cannot be set when Match Drive is selected for the Pre-amplifier Type.
*3: The setting range is -100 to 0 when Match Drive is selected for the Pre-amplifier Type.
Noise Suppressor
G-Amp
Speaker Modeling
Output L
Output R
Input L
Input R
VS-2000_e.book 42 ページ 2005年12月12日 月曜日 午後4時54分

Other manuals for Roland VS-2000

Related product manuals