Roland VS-2000 - Page 50

50
Algorithm List
3band Isolator
Sharply cuts off components by frequency band to eliminate undesired sounds. Useful to eliminate undesired sounds and take out
only specific sounds from a CD. Isolator can make sounds completely perish, unlike ordinary equalizers that leave some sounds
even with the gains of the respective frequency bands set to the minimum.
fig.08-69
Parameter (full name) Setting Function
Iso (3-band Isolator): Divides the input sound into three frequency bands to abstract or eliminate the sound.
Sw (Switch) On, Off Turns the 3-band isolator on or off.
AntiPhase LoLev
(Anti-phase Low Level) 0–100 Sets the amount of the low frequency band sound should be muted.
AntiPhase MidLev
(Anti-phase Middle Level) 0–100 Sets how much of the middle frequency band sound should be muted.
LoMixSw
(Anti-phase Low Mix Switch) On, Off Mutes or leaves the low frequency band sound.
MidMixSw
(Anti-phase Middle Mix Switch) On, Off Mutes or leaves the middle frequency band sound.
LowLvl (Low Level) -60– +4 dB Increases or decreases frequency bands in the low frequency band.
MidLvl (Middle Level) -60– +4 dB Increases or decreases frequency bands in the middle frequency band.
HiLvl (High Level) -60– +4 dB Increases or decreases frequency bands in the High frequency band.
3 Band
Isolator L
3 Band
Isolator R
Input L
Input R
Output L
Output R
Muting the bass
Set up as follows to eliminate low frequency band sounds such as bass sounds.
Anti-phase Low Mix Switch (AntiPhase LoMixSw):On
Anti-phase Low Level (AntiPhase LoLev):Relatively High
Muting vocals
Set up as follows to eliminate middle frequency band sounds such as vocal sounds.
Anti-phase Middle Mix Switch (AntiPhase MidMixSw):On
Anti-phase Middle Level (AntiPhase MidLev):Relatively High
Muting noise
Identify the frequency band of the noise and set the relevant Level (LowLvl, MidLvl or HiLvl) to -60 dB.
VS-2000_e.book 50 ページ ２００５年１２月１２日 月曜日 午後４時５４分