Roland VS-2000 - Page 54

54
Algorithm List
Stereo Multi
fig.08-47
Parameter (full name) Setting Function
NS (Noise Suppressor): Mutes noise in the silent mode.
Sw (Switch) On, Off Turns the noise suppressor on or off.
Thresh (Threshold) 0–100 Sets the level to start muting noise.
Release (Release) 0–100 Sets the time over which the volume will drop to 0 after the noise starts being muted.
Cmp (Compressor/Limiter): Compresses the entire output signals when the input volume exceeds a specified value.
Sw (Switch) On, Off Turns the compressor on or off.
Thrsh (Threshold Level) -60–0 dB Sets the level at which the compressor starts taking effect.
Ratio (Ratio) 1.5:1, 2:1, 4:1, 100:1 Sets the compression ratio applied when the threshold level is exceeded.
Attack (Attack Time) 0–100 Sets the time from when the input level exceeds the threshold level to when the effect begins to
apply.
Release (Release Time) 0–100 Sets the time from when the input level drops below the threshold level to when the effect ceases
to apply.
Level (Output Level) -60–12 dB Sets the volume of the compressor sound.
Enh (Enhancer): Accentuates the sound and push the sound forward.
Sw (Switch) On, Off Turns the enhancer on or off.
Sens (Sense) 0–100 Sets the degree of the enhancer effect desired.
Freq (Frequency) 1.0–10.0 kHz Sets the frequency at which the enhancer effect starts working.
MixLvl (Mix Level) 0–100 Sets the amount of the enhancer sound should be mixed into the direct sound.
Level (Level) 0–100 Sets the volume of the enhancer sound.
EQ (Equalizer)
Sw (Switch) On, Off Turns the equalizer on or off.
Low Gain (Low Gain) -12– +12 dB Sets the boost/cut amount in the low frequency band.
Low Freq (Low Frequency) 20 - 2000 Hz Sets the center frequency in the low frequency band.
Low Q 0.3–10.0 Sets the width of the area around the low frequency that
will be affected by the gain settings. *1
Low Type Shlv, Peak Sets the type of the low frequency band equalizer (Shlving type or peaking type).
Mid Gain (Middle Gain) -12– +12 dB Sets the boost/cut amount in the middle frequency band.
Mid Freq (Middle Frequency) 200–8000 Hz Sets the center frequency in the middle frequency band.
Mid Q (Middle Q) 0.3–10.0 Sets the width of the area around the middle frequency that will be affected by the gain settings.
High Gain -12– +12 dB Sets the boost/cut amount in the High frequency band.
High Freq (High Frequency) 1.4–20.0 kHz Sets the center frequency in the High frequency band.
High Q 0.3–10.0 Sets the width of the area around the High frequency that will be affected by the gain settings. *1
Hi Type (High Type) Shlv, Peak Sets the type of the High frequency band equalizer (Shlving type or peaking type).
Level (Output Level) 0–100 Sets the volume after passing through the equalizer.
*1: If Low Type (Lo Type) or High Type (Hi Type) is set to “Shlv (Shlving Type),” the setting for Lo Q or High Q is invalid.
Input L
Input R
Output L
Output R
Noise
Suppressor
Noise
Suppressor
3BAND EQ
3BAND EQ
Enhancer
Enhancer
Compressor/
Limiter
Compressor/
Limiter
VS-2000_e.book 54 ページ ２００５年１２月１２日 月曜日 午後４時５４分