ROLEC EV Series User Manual

EV: BASICCHARGE
PEDESTAL
Doc No.: EVBAI-001 Rev: 01
OPERATING INSTRUCTIONS
Status Indicator Guide
 Flashing blue light - Ready for Charge (IEC socket only)
 Fixed blue light - Cable plugged in but not charging
 Fixed green light - Charging in progress
 Flashing red light - Fault indicated - Switch off unit at source and switch back on after 20 secs to
clear fault. If fault persists, contact your installer
Vehicle Charging
 Ensure the status indicator shows a blue light
 Insert your charging cable into the vehicle first and then insert the other end into the charging
point socket
 Ensure the status indicator changes to a fixed green light
 To disconnect: remove the plug from the vehicle first then remove the plug from the charging
point socket; this allows time for the lock to disengage in the socket
LED Lamp
 Cover the light sensor, located on the left hand side of the front skin and ensure that the LED
lamp illuminates
 Uncover the light sensor and ensure that the LED lamp extinguishes
13 A socket (if fitted)
 Ensure the switchgear is turned on
 Open the flap and plug in
 Upon completion, unplug and secure the flap
Key Switch option (if fitted)
Set the key switch to On to activate; the key may then be removed. To deactivate, insert the key and turn:
the key may then be removed.
Amp Selector option (if fitted)
Set the selector to the required position 16A or 32A prior to connecting to the vehicle.
Solar Switch option (if fitted)
Set the switch to the required position 6A, 13A,16A or 32A prior to connecting to the vehicle.
Time Clock option (if fitted)
For units fitted with a time clock option set the clock as follows:
 Lift the hinged timer cover to access the dial
 Set the tabs to the right to select the time of the charge and its duration
 Set the dial to display the current time
 Set the three position On/Clock/Off switch to the central (clock) position
 Close the hinged timer cover
To override the clock and have the unit on permanently, set the three position On/Clock/Off switch to the On
position.
To prevent timer operation set the three position On/Clock/Off switch to the Off position.

ROLEC EV Series Specifications

General

Operating Temperature	-30°C to +50°C
Connector Type	Type 2
Mounting Options	Wall, Pedestal
Connectivity	Ethernet
Protection Rating	IP65
Charging Standard	IEC 61851
Input Voltage	230V AC (Single Phase)
Current	32A
Compliance	CE
Smart Features	Remote monitoring, Load balancing
Cable Length	5m