Roli Lightpad Block - Charging Times; Cleaning the Lightpad Block

The battery will retain over 80% of its capacity for over 300 charge cycles. A charge cycle is
defined as a complete discharge from 100% to 0%, and subsequent recharge back to 100%. For
example, charging a device going from 50% charge up to 100% and back twice would be
equivalent to one charge cycle.
Charging Times
BLOCKS
Watts
Time to charge
Lightpad Block
5W——-12W
4 hours ————— 3 hours
Lightpad Block + Live Block
10W——-12W
4 hours ————— 3 hours
Lightpad Block+ Live Block + Loop Block
10W——-12W
4 hours ————— 4 hours
Additional Information
Battery Life
4 hours when in use; 6 months when turned off (on firmware 0.2.0+)
Bluetooth Range
15 meters
Bluetooth Latency
30 ms touch to sound
USB Latency
10 ms touch to sound
LEDs
225 on surface, 2 indicator LEDs on power button & mode button
Mass
250g
Dimensions
94mm x 94mm x 20mm
Ports
USB-C port (MIDI out and power)
Connectivity
Full MIDI compatibility over USB and Bluetooth LE
DNA Connectors
8
Buttons
Mode / Power & Bluetooth
Included in package
Lightpad, USB-C to USB-A Cable, Quickstart Guide, Warranty Information
Cleaning the Lightpad Block
Basic care and attention will protect your Lightpad Block and help it stay in optimal condition.
Keep it away from direct sunlight, sharp objects or edges, corrosive solvents, liquids, and
especially oils – including greasy fingers after eating food. The Lightpad Surface is designed for
finger and hand pressure/impact, but NOT for hard objects, such as drum sticks.
To clean the Lightpad Surface you may use damp, bleach-free and oil-free cleansing wipes. Do
not use any abrasive cleansing agents on the Lightpad Block.