Notice originale : Français NT0002 V –p – 03/2014
Installation of the auto-pilot system:
The auto-pilot axle requires the installation of a pilot cylinder. According to your trailer, you
may have to mount one or two clevis mountings in your tractor. These clevis mountings aren´t
warranted by ROLLAND. According to the brand and model of the tractor the positions of
clevis mountings may vary.
For one auto-pilot axle For two auto-pilot axles
When the tractor is fully blocked, check that there is approximately
20mm margin at the piston rods of rolling i.e. they are not completely in
or out.
Mounting the clevis:
The axle of the ball cylinder must have a minimum distance of :
180 mm for a simple cylinder mounting
120 mm / 160 mm for a double cylinder mounting
The ball cylinder´s axle must be remote:
18 mm of the boom/jib´s axle.
To Next Page
Loading...