2 comments :
A system for counter roll of the vehicle is provided in the assembly. Oil will never
"take the easy route". The load will constantly be equal over the four wheels, which
allows us also to "dispense" with tipping stabiliser.
The pressure relief valve is intended for smoothing out any abnormal pressure
peaks (violent dynamic shocks).
3- RECOMMENDATIONS FOR SETUP AND USE
a. To increase the height of the suspension (raising the body) :
To add oil to the suspension system (if, for example, the height is
considered insufficient), proceed as follows:
Connect the hose identified by a marking (long green) to the tractor.
Open the two outer taps of the block (see photo). The middle tap must be
closed.
Supply the oil circuit via the hose connected to the tractor until the required
height is achieved.
Close the two outer taps again and open the middle tap.
Release the residual pressure present in the hose by positioning the tractor
distributor on "float"
Disconnect the hose (long green) from the tractor.
Only the return drain hose (short green) remains connected.
WARNING Note that the height of the skip will vary depending on
the load present inside.
To Next Page
