19
Assemble the Steering Wheel
1. Use a Phillips head screwdriver to remove the screw on the battery
compartment of the steering wheel
2. Insert two AA batteries into the battery compartment
3. Replace cover and use the screwdriver to fasten
4. Locate the steering wheel screw (24) and nut (25) from blister pack wheel
5. Hold the steering rod by hand, and slide the steering wheel (3) onto the
steering rod
6. Align the holes on the steering wheel with the holes on the steering rod
7. Slide the steering wheel screw (24) through the steering wheel and
steering rod
8. Fasten the nut (25) to the end of the screw and tighten the screw with a
screwdriver
WARNING!
DO NOT mix old and new batteries.
DO NOT mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
25
24
To Next Page
Loading...
