A
...
'A'
Service Schedule - Every 10 000 kilometres
(6 000 miles)
or
6
months
whichever
is
the
earlier
• 1.
Battery:
Check the
electrolyte
I eve I; top•up
with
distilled
water
if
necessary.
• 2. Brakes: Inspect the footbrake and parking
brake pad
linings;
fit
new pads
if
necessary.
When
renewing the pads, examine the
caliper
dust
excluders and renew
if
necessary.
Manually
adjust
the parking brake
caliper
mechanism.
Inspect pipes and connections. Report any
defects
to
the Owner.
* 3. Engine: Change the engine
oil
and
fit
a new
oil
filter
element.
• 4. Torque converter transmission: Check the
fluid
level
with
the engine running and top-up if
necessary.
5.
Belts
and
belt
tension: Check the
condition
and tension
of
the coolant pump, steering pump and
ref_ri
gerati on compressor and al tern a tor d
riving
belts;
adJust
or
replace as necessary.
6.
Control linkages:
Lubricate
the
accelerator
I in kage and the gear range
selector
controls
(adjacent
to
the transmission casing)
with
engine oi
I.
.
7._
Electrical
sy~tem: Check
all
exterior
lamps,
1ntenor lamps, warnmg lamps and
devices
and
instruments
for
correct operation;
rectify
as
necessary.
t 8.
Ignition
timing and
idle
speeds: Check the
ignition
timing with a stroboscope and
adjust
if
necessary.
Check
the
engine
idle
speed and choke
idle
speed;
adjust
if
necessary.
9.
Parking
brake I inkage:
Lubricate
the
pivot
pins
and
pulleys
with
the approved grease.
10.
Levels
and pressures: Check the
fluid
level
of
the
steering
pump
reservoir; top-up
if
necessary.
Check the
level
and
specific
gravity
of
the
engine
coolant;
correct as necessary.
Check the
fluid
level
in the windscreen washer
reservoir and top-up
if
necessary.
Run the engine for four minutes then check the
levels
of
the
hydraulic
system reservoirs; top-up
if
necessary
using
recommended hydrau I
ic
system
mineral
oil.
Check and
adjust
all
tyre pressures;
also
check
tyre tread depth and tyre
condition.
Report
any defects to the Owner.
11.
Test:
Road
test
the
car
for
satisfactory
performance.
'8'
Service Schedule - Every 20 000 kilometres
(12 000 miles)
or
12
months
whichever
is
the
earlier
• t 1.
Air
filter/silencer:
Fit
a new
filter
element.
• 2.
Battery:
Check the
electrolyte
level;
top-up
with
distilled
water
if
necessary.
• 3. Brakes: Inspect the footbrake and parking
E21
··
2
brake pad
linings;
fit
new pads
if
necessary.
When
renewing brake pads, examine the
caliper
dust
excl uders and renew
if
necessary.
Manually
adjust
the parking brake
caliper
mechanism.
Inspect pipes and connections. Report any
defects to the Owner.
•
4.
Engine: Change engine
oil
and
fit
a new
oil
filter.
• t 5. Engine breather system: Remove and clean
the gauze flame trap in the crankcase breather tube,
also
clean the breather connection in the
air
filter
housing on the carburetter.
• 6.
Final
drive
unit:
Check the
oil
level;
top-up
if
necessary.
* 7.
Front
suspension: Inspect the front suspension
ba
11
joint
rubber covers;
if
the covers are damaged.
fit
new
joints
and
covers.
• 8.
Ignition
system:
Lubricate
the
distributor
spindle
{shaft bearings) and automatic advance
mechanism
with
clean engine
oi
I.
Fit
new sparking
plugs.
*t'9.
Ignition
timing and
idle
speeds: Check the
ignition
timing
with
a stroboscope and
adjust
if
necessary.
Check the engine
idle
speed and choke
idle
speed;
adjust
if
necessary.
Ensure exhaust emissions comply
with
E.C.E.
Regulation 15,
if
applicable.
•
10.
Steering ball
joints:
Lubricate
the
steering
ball
joints
at
the four grease
points.
Inspect the
rubber covers on the
ball
joints;
if
the covers are
damaged the
joints
should be dismantled and new
parts
fitted
as necessary.
•
11.
Steering
rack
and
pin
ion assembly: Inspect the
convoluted neoprene seals
on
the rack and pinion
unit
and check the seal
clips
for
tightness;
if
the
seals
are damaged new seals should be
fitted.
• 12. Torque converter
transmission:
Change
transmission
fluid.
13.
Belts
and
belt
tension: Check the condition
and tension of the coolant pump,
steering
pump
and
refrigeration compressor and
alternator
driving
belts;
adjust
or
replace as necessary.
14.
Control I inkages:
Lubricate
the accelerator
I inkage and the gear range
selector
controls
(adjacent to the transmission casing)
with
engine
oil.
15.
Electrical
system: Check al I
exterior
lamps,
interior
lamps, warning lamps and
devices
and
instruments
for
correct operation;
rectify
as
necessary.
16.
Parking
brake linkage:
Lubricate
the
pivot
pins and
pulleys
with
approved grease.
17. Spare wheel carrier:
Lubricate
the spare
wheel
carrier
lowering
bolt
and mechanism.
18.
Levels
and pressures: Check the
fluid
level
of the
steering
pump
reservoir; top-up
if
necessary.
Check the
level
and
specific
gravity
of
the
engine coo I ant; correct
if
necessary.
Check the
fluid
level
in the windscreen washer
reservoir and top-up
if
necessary.
To Next Page
Loading...
