C
"'
.....
m
-
Run the engine for four minutes then check the
levels
of
the
hydraulic
systems reservoirs; top-up
if
necessary using recommended
hydraulic
system
mineral
oil.
Check and
adjust
al I tyre pressures;
also
check tyre tread depth and condition
of
tyres. Report
any defects to the Owner.
19.
Test:
Road test the
car
for
satisfactory
performance.
'C'
Service Schedule -
Every
40
000
kilometres
(24
000
miles)
or 2 years whichever
is
the
earlier.
In addition to the 20 000 kilometres (12 000 miles)
service
schedule carry out the
following.
In the case of the Carburetters,
Final
drive
unit,
Torque converter transmission and
Levels
and
pressures,
servicing
necessary
is
listed
in
this
schedule therefore, the 20 000 kilometres (12 000
miles) service schedule should not
be
consulted
for
these items,
• t 1. Carburetter: Remove and clean the f i I
ter
in
the fuel
inlet
connection.
" 2. Engine cooling system:
Fit
a new thermostat.
Examine the condition
of
all
hoses;
fit
new hoses
as
necessary.
Fit
new heater tap feed hose
(irrespective
of
visual appearance).
• 3.
Final
drive
unit:
Change the
oil.
• 4. Torque converter transmission: Change the
transmission
fluid
and
fit
a new
intake
strainer.
Renew
'O'
ring
on
intake pipe and
fit
a new seal to
bore
of
intake
strainer.
5. Fuel
filter:
Clean out the
filter
bowl and
fit
a
new
filter
element.
6.
Fuel
pumps: Remove pumps and
test
fuel
pump
efficiency;
fit new pumps
if
necessary.
7.
Fuel tank: Release the fuel tank drain plug
and
allow
any accumulated water to drain away;
fit
the drain plug.
8.
Height
control mechanism: Disconnect, clean
and
lubricate
the height control valve
ball
joints;
connect the
ball
joints.
9.
Propeller
shaft:
Lubricate
the universal
joints
at
each end
of
the shaft
with
approved grease.
10. Rear wheel drive-shafts:
Lubricate
the outer
universal
joints
with approved grease •
11.
Levels
and pressures: Check the
fluid
level
in
the steering
pump
reservoir; top-up
if
necessary.
Check the level and
specific
gravity
of
the
engine coolant; correct
if
necessary.
Check the
fluid
level
in
the windscreen washer
reservoir and top-up
if
necessary.
Run the engine for four minutes then check
the
levels
of
the
hydraulic
system reservoirs;top-up
if
necessary using recommended
hydraulic
system
mineral
oil.
Check and
adjust
al I
tyre
pressures;
also
check
tyre tread depth and tyre con di ti on. Report any
defects to the Owner.
On
Convertible
cars, check the
fluid
level
in
the power operated hood mechanism reservoir
with
the hood in the
fully
down (open)
position;
top-up
if
necessary
with
approved
fluid.
Additional Service Items
Seasonal
Every
12
months
- 'SA'
(Autumn)
Service
Engine coo
Ii
ng system: Drain
off
the
old
coolant and
fi
11
the system
with
fresh
anti-freeze/water
mixture.
Just
prior
to Autumn clean any debris from the
surfaces of the refrigeration condenser and radiator
matrices by reverse
flushing
with
a hose.
Body drain
holes:
Ensure that the body drain holes
are not obstructed.
Every 12
months
•
·ss•
(Spring) Service
Air
conditioning
system: Check that the foam
filter
element in the
scuttle
intake
grille
is
free from
obstruction;
fit
new element(s)
if
necessary.
Check the refrigeration system for correct
operation;
rectify
as necessary. Any work
on
the
refridgeration system must only be carried
out
by an
experienced engineer.
Every 2 years - 'SC' (Autumn) Service
Engine
cooling
system: Carry
out
the 12 months
'SA'
(Autumn) Service procedure and also thoroughly
reverse flush the
cooling
system. Examine coolant
hoses and
fit
new hoses as necessary.
Hydraulics
Only use
hydraulic
system mineral oi I components.
Under no circumstances should components for use
with
conventional brake
fluid
(RR363) be used
for
replacements.
Every 80 000 kilometres (48 000 mites)
or
4 years
-
'HA'
Service
Brake and
hydraulic
systems:
Fit
new accumulator
to frame hoses. Examine the condition of the
sub-
frame to brake
caliper
hoses;
fit
new hoses where
necessary.
Drain
off
the
hydraulic
system mineral
oil;
clean
out
the
hydraulic
reservoirs.
Fill
the
systems
with
fresh
hydraulic
system mineral
oil
and bleed the systems.
Every 160 000 kilometres (96 000 mile.s)
or
8 years
•
'HB'
Service ·
Brake and
hydraulic
systems:
Fit
all
new
flexible
hoses to the brake and hydrau!
ic
systems.
Fit
new
seals to the
disc
brake
calipers
and the deceleration
conscious pressure I
imiting
valve.
Drain
off
the
hydraulic
system mineral
oil;
clean out the reservoirs.
Fi
II the systems
with
fresh
hydraulic
system mineral oi ! and bleed the systems.
E21
- 3
To Next Page
Loading...
