inspect
the tyres
for
damage. Report any defects
to
the Owner.
Check and
if
necessary balance the wheels.
14. Check the
following
levels:
Check the
fluid
level
in
the steering
pump
reservoir and top-up
if
necessary.
Check the I eve I and
specific
gravity
of the
engine coolant and correct
if
necessary.
Run
the engine
for
four minutes then check the
fluid
levels
of the
hydraulic
braking systems
reservoirs; top-up
if
necessary with the approved
fluid.
Check the
fluid
level
in
the windscreen
washer reservoir and top-up
if
necessary.
15.
Test:
Road
test
the
car
for
satisfactory
performance.
'B'
Service Schedule· Every 20 000 kilometres
(12 000 miles)
or
12
months
whichever is the
earlier
•t1
Air
silencer
and fi
lier:
Remove
and
clean
the wire mesh
filter
element.
• 2.
Battery:
Check the
electrolyte
level:
top-up
with
distilled
water
if
necessary.
• 3. Brakes: Remove the brake drums and
inspect
linings
for
wear; renew
lining
if
necessary.
Check and
if
necessary
adjust
the rear brakes.
Inspect pipes and connections. Report any
defects to the Owner.
"t4.
Carburetters: Check the
oil
level
in
the
air
valve dampers and
if
necessary top-up to correct
level.
Check
float
chamber depression and
rectify
if
necessary.
Check
the
engine
idle
speed and choke
idle
speed;
adjust
if
necessary.
Ensure exhaust emissions comply
with
E.C.E.
Regulation 15,
if
applicable.
• 5. Engine: Change engine
oil
and
fit
a new
oil
filter.
•ts.
Engine breather system: Remove and clean
the flame traps in the crankcase breather tube and
also
clean the adapter
in
the choke
butterfly
housing.
" 7.
Final
drive
unit:
Check the
oil
level
and top-up
if
necessary.
• 8.
Front
suspension:
Lubricate
the
eight
grease
nipples
on the front suspension
with
the approved
grease.
•t9.
Ignition
system:
Lubricate
the
distributor
spindle
(shaft
bearings) and automatic advance
mechanism
with
clean engine
oil.
Fit
new sparking plugs.
Check
ignition
timing
with
stroboscope and
adjust
if
necessary.
* 10. Propel I er shaft:
Lubricate
the uni versa
Is
joints
and the
sliding
joint
with
approved grease
(applicable
only
to the Hardy Spicer type
propeller
shaft).
"11.
Steering mechanism:
Lubricate
the thirteen
grease
nipples
with
the
approved grease. Inspect the
rubber covers on the ball
joints;
if
the covers are
damaged the
joints
should be dismantled and new
parts
fitted
as necessary.
DS
- 2
• 12. Torque converter transmission: Change
transmission
fluid.
13.
Belts
and
belt
tension: Check the condition
and
tension of the alternator, coolant
pump
and
steering pump/ refrigeration compressor
driving
belts;
adjust
or
replace as necessary.
14. Brake linkage:
Lubricate
the brake linkage
clevis
and tu lcrum pins of the
pu
11
rods and
inter-
mediate
levers
with
the approved grease.
15. Control I inkages:
Lubricate
the
accelerator
I inkage and the gear range
selector
controls
(adjacent
to
the transmission casing) with clean
engine
oil.
16.
Electrical
system: Check al I
exterior
lamps.
interior
lamps, warning lamps and
devices,
and
instruments for correct operation;
rectify
as
necessary.
17.
Parking
brake linkage:
Lubricate
the
pivot
pins
and
pulleys
with
the approved grease.
18. Shock dampers: Check
fluid
levels
and
top-up
if
necessary
with
approved
fluid.
Inspect the
dampers
for
fluid
leaks and report any
defects
to the
Owner.
19. Wheels and tyres: Check and
if
necessary
adjust
the
tyre
pressures.
Inspect
the
tread depth of
all
tyres;
also
inspect the
tyres
for
damage. Report any defects
to the Owner.
Check and
if necessary balance the wheels.
20. Check the
following
levels:
Check the
fluid
level
in
the power steering
purr.p
reservoir and top-up
if
necessary.
Check the
level
and
specific
gravity
of the
engine
coolant
and correct
if
necessary.
Run the engine
for
four minutes then check the
fluid
levels
of the
hydraulic
systems reservoirs;
top-up
if
necessary
with
the approved
fluid.
Check
the
fluid
level
in
the windscreen washer
reservoir; top-up
if
necessary.
21.
Test:
Road
test
the car
for
satisfactory
pert ormance.
'C'
Service Schedule - Every 40 000 kilometres
(24
000
miles)
or
2 years whichever
is
the
earlier
~
1.
Air
silencer
and
filter:
Remove and clean the
wire mesh
filter
element.
•t2.
Automatic choke: Check the
flow
through the
choke stove pipe and check
for
correct functioning;
rectify
if
necessary.
" 3.
Battery:
Check the
electrolyte
level;
top-up
with
distilled
water
if
necessary.
• 4. Brakes: Remove the brake drums
and
inspect
linings
for
wear; renew
linings
if
necessary.
Check and
if
necessary
adjust
the rear brakes.
Inspect pipes and connections. Report any
defects to
the
Owner.
*
ts.
Carburetters: Clean the
air
valves; top-up the
oil
level
in the
air
valve
dampers.
Fit
new paper element
filters
to the fuel
inlet
connections.
Check
float
chamber depression and
rectify
if
necessary.
To Next Page
Loading...
