Check engine
idle
speed and choke
idle
speed;
adjust as necessary.
Ensure exhaust emissions comply
with
E.C.E.
Regulation 15,
if
applicable.
• 6. Engine: Change the engine
oil
and
fit
a new
oil
filter.
"t7.
Engine breather system: Remove and clean
the gauze flame traps in the crankcase breather
tube.
Clean the adapter
in
the choke
butterfly
housing.
• 8. Engine
cooling
system:
Fit
a new engine
cool ant thermostat.
Examine the condition of
all
hoses;
fit
new
hoses as necessary.
Fit
new heater tap hoses
(irrespective
of visual appearance).
• 9.
t-=inal
ctrive
unit:
Drain the
final
drive
unit
and
fill
with recommended
oil.
"10.
Front suspension:
Lubricate
the
eight
grease
nipples
on
the front suspension
with
the approved
grease.
"i11. Fuel mixture weakening
device
filter:
Fit
a
new fuel mixture weakening
device
filter.
"t12.
Ignition
system:
Lubricate
the
distributor
spindle
(shaft bearings) and automatic advance
mechanism
with
clean engine oi I.
Fit
new sparking plugs.
Check
ignition
timing
with
stroboscope and
ad
just
if
necessary.
* 13.
Propeller
shaft:
Lubricate
the universal
joints
and the
sliding
joint
with
approved grease
(applicable
only
to the Hardy·Spicer type propeller
shaft).
* 14. Steering mechanism:
Lubricate
the thirteen
grease nipples
with
the approved grease. Inspect
the rubber covers
on
the bal I
joints;
if
the covers
are damaged the
joints
should
be
dismantled and
new parts
fitted
as necessary.
* 15. Torque converter transmission: Change the
transmission
fluid
and
fit
a new intake
strainer.
Renew
·o·
ring on
intake
pipe
and
fit
a new seal to
bore of intake strainer.
16.
Belts
and
belt
tension: Check the condition
and
tension of the alternator, coolant
pump
and
steering pump/refrigeration compressor
driving
belts;
adjust
or replace as necessary.
17. Brake I inkage:
Lubricate
the brake I inkage
clevis
and fulcrum
pins
of
the
pu
11
rods and
inter-
mediate levers
with
the approved grease.
18. Control
Ii
nkages:
Lubricate
the
accelerator
linkage and the gear range
selector
controls
(adjacent to the transmission casing)
with
clean
engine oi I.
19.
Electrical
system: Check al 1
exterior
lamps,
interior
lamps, warning lamps and
devices,
and
instruments
for
correct operation;
rectify
as
necessary.
20. Fuel
filter:
Clean out the
filter
bowl and
fit
a
new
fitter
element.
21. Fuel pumps: Remove pumps
and
test
fuel
pump
efficiency;
fit
new pumps
if
necessary.
22. Fuel tank: Release the fuel tank drain plug
and
allow
any accumulated water to drain away;
fit
the drain plug and add four S.B.N.
inhibitors
to the
tank.
23.
Parking
brake linkage:
Lubricate
the
pivot
pins
and
pulleys
with
the approved grease.
24. Propel
!er
shaft: Check the torque
lightness
of
the
bolts
securing the
shaft
flanges;
rectify
if
necessary.
25. Shock dampers: Check the
fluid
levels
and
top-up
if
necessary
with
the approved f I u
id.
Inspect
the dampers
for
fluid
leaks and report any defects
to the Owner.
26. Steering
transfer
box: Check the oi I
level;
top..up
if
necessary.
27. Wheels and tyres: Check and
if necessary
adjust
the tyre pressures.
Inspect the tread depth of al I tyres;
also
inspect the tyres for damage. Report any
defects
to the Owner.
Check and
if
necessary balance .the wheels.
28. Check the
following
levels:
Check the
fluid
level
in
the
power steering
pump
reservoir and top-
up
if
necessary.
Check
the
level
and
specific
gravity
of
the
engine coolant and correct
if
necessary.
Run the engine for four minutes then check the
fluid
levels
of the
hydraulic
systems reservoirs;
top-up
if
necessary
with
the recommended
fluid.
Check the
fluid
level
fn
the windscreen
washer reservoir; top-up
if
necessary.
29.
Test:
Road
test
the
car
for
satisfactory
performance.
Additional
Service
Items
Seasonal
Every
12
months
-
'SA'
(Autumn) Service
Engine
cooling
system: Drain
off
the old
coolant
and fi
11
the system
with
fresh
anti-freeze/water
mixture.
Just
prior
to Autumn clean any debris from
the surfaces of the refrigeration condenser and
radiator
ma
tri
c·es
by reverse f I ush i ng
with
a hose.
Every 12 months - 'SB' (Spring) Service
Air
conditioning
system: Check
that
the foam
filter
element
in
the
scuttle
intake
grille
is
free from
obstruction;
fit
a new element
if
necessary. On cars
fitted
with
a fresh
air
intake
in the rear decking
panel, above the rear
refrigeration
unit,
also
_check
that the
filter
element
in
this
intake
is
free from
obstruction;
fit
a new
filter
element
if
necessary.
Check the
refrigeration
system
for
correct operation;
rectify
as necessary. Any work on the refrigeration
system must
only
be carried out by
an
experienced
engineer.
Every 2 years - 'SC' (Autumn) Service
Engine
cooling
system: Carry
out
the
12
months
'SA' (Autumn) Service procedure and al so
thoroughly reverse
flush
the
cooling
system.
Examine
coolant
hoses and
fit
new hoses as
necessary.
05
- 3
To Next Page
Loading...
