Parking brake linkage
Lubricate
the
pivot
pins
and
pulleys
in
the parking
brake system
with
approved grease.
Spare wheel carrier
Lubricate
the spare wheel
carrier
I oweri
ng
bolt
and
mechanism.
Tyres
Check the tread depth of al I tyres, inspect al I
tyres
for
signs
of
damage. Check the tyre pressures
when they are cold and
adjust
if
necessary.
Note
Inc I
ude
the spare tyre.
Test
Road test the
car
for
satisfactory
performance.
Seasonal Schedules
Every 12 months
Engine cooling system
Drain
the coolant from radiator and engine
crankcase.
Fi
11
with
the correct anti ·freeze mixture.
Clean any debris from the surfaces of the
refrigeration
condenser and radiator matrices by
reverse flushing with a hose.
This
should be carried
out
just
prior
to the autumn.
Body
drain
holes
Check that the body drain holes are unobstructed.
Air
conditior:iing system
Check that the foam
filter
element(s)
fitted
to the
scuttle
intake
grille
is
free from obstruction.
Refrigeration system
Check the
refrigeration
system
for
correct operation,
rectify
if
necessary. Any work must
be
carried out
by
an
experienced engineer.
Every 2 years
In addition to 12 monthly seasonal schedule,
carry out the fol lowing operation.
Engine cooling system
When
the coolant has been drained, thoroughly
reverse flush the cool ant passages
with
a
con·
ti
nuous
flow
of
water.
Fit
new hoses where
necessary.
Service Recommendations
For
convenience these
services
may
be
carried out
at
the brake
pad
renewal nearest to the
specified
mileage.
Every 80 000 kilometres (48 000 miles)
At
this
mileage under normal motoring
conditions
it
is
recommended that the
following
servicing
is
carried
out.
Automatic height control and braking systems
Examine the sub-frame to brake
caliper
hoses
for
chafing
or
surface
cracking;
renew
if
necessary.
Fit
new front and rear accumulator to frame hoses.
E17 - 8
Every 160 000 kilometres (96 000
miles)
At
this
mileage under normal motoring condi
lions
it
is
recommended
that
the
following
service
is
·
carried out.
Automatic height control and braking systems
Fit
all
new
flexible
hoses to the braking systems
and automatic
height
control system.
Fit
new seals to the
disc
brake
calipers
and
the
deceleration conscious pressure
limiting
valve.
Fuel system
Fit
a new convoluted rubber hose between the fuel
filler
head and fuel tank assembly.
Examine al I
flexible
fuel
pipes
and renew any
which
show
signs
of
deterioration.
To Next Page
Loading...
