Replacing the Battery
This organizer uses 1 CR2032, 3-volt lithium bat-
tery. Before you follow these steps you should
have a small Phillips screwdriver (one that fits into
screws with and “x” notch) and the new battery at
hand.
Warning! When no batteries are installed, this
organizer will save your information for only about
30 seconds. So quickly install the new battery
once you remove the old one.
1. Turn the organizer off and turn it over.
2. Use a Phillips screwdriver to remove the
screw on the battery cover and then remove
the cover.
3. Remove the old battery and insert the new
one with the positive (+) side facing up.
4. Replace the battery cover.
Warning! If RESET? appears when you next turn
on the organizer, do not tap ENTER unless you
want to reset the organizer and erase all your
entered information. Tap any other key instead.
33
To Next Page
Loading...