Rommelsbacher ES 850/E - Functionality; Integrated Safety System; Integrated Motor Protection

16
o Do not operate the unit in the vicinity of sources of heat (oven, gas flame
etc.) or in explosive environments, where inflammable liquids or gases are
located.
o Place it beyond children’s reach.
o Leave a sufficient space around the appliance to ensure an unobstructed
working area. See to a free air circulation.
• Pull the mains plug after each use for safe switch-off.
Functionality
Integrated safety system
The food is filled-in through the filling hole and pressed down with the pusher. The food gets on the quickly
rotating grater and is grated finely. Due to the centrifugal force, the grated food is pressed on the aslant surfaces
of the micro-mesh filter. There, the juice is extracted. The pulp is thrown out; the gained juice gets in the juice
container and in a vessel via the spout.
The higher the speed setting, the higher is the rotation speed of the grater. The speed level has influence on the
juicing results. You can select the settings to your individual taste.
The appliance has a double protection. It can only be operated if both locking clamps are closed and have engaged
properly. Together with the observance of the advices of this instruction manual, this safety system ensures a safe
operation of the appliance.
Integrated motor protection
The appliance has an integrated motor protection against overheating which prevents the motor from getting
damaged in case of overloading.
o If the power plug gets connected to the mains but the rear locking clamp is not shut correctly, the display
remains off.
o If the rear locking clamp is opened during operation, the appliance will stop and the display goes out.
After having closed the clamp again the appliance restarts at the set speed level.
o If the power plug gets connected to the mains but the front locking clamp is not shut properly, the display
will show a blinking “L”.
o After the correct locking of the front clamp the display will show “0”.
o If the front locking clamp is opened during operation, the appliance will stop and the display shows a
blinking “L”. As soon as the clamp gets relocked the appliance will restart at the set speed level.