17
Prior to initial use
For a start, please clean the appliance as well as all attachments. For more detailed information please refer to
“Cleaning and maintenance”.
o If the motor temperature rises over 110 °C the appliance will stop automatically and the temperature
indication in the display starts blinking.
o Wait until the motor has cooled down below 100 °C.
o For a restart of the appliance turn the rotary knob to “OFF“ position first and then select the desired speed
level.
ATTENTION: Hazard of injury! The grater keeps running for
ca. 10 – 15 seconds after it has been switched off; therefore
disassemble the juicer only at standstill!
Do not grasp in the filling hole and the grater! The grater is very
sharp; handle it with care to avoid injuries!
Disassembly and assembly
How to disassemble your appliance
• Switch the appliance off.
Turn rotary knob to “OFF“ position and pull the mains plug!
• Remove the pulp container.
To do so, take the pulp container at the recessed grips and lift the container slightly until it comes off the base
lock. Afterwards tilt the container slightly and remove it.
• Remove the top cover.
Open both locking clamps and fold them aside. Now, remove the top cover. Then remove the pusher from the
filling hole.
• Remove the juice container and the grater.
Position your thumbs one below the spout, one below the fixture of the lock for pulp container. Then slightly
push the juice container upwards until the grater disengages. Cautiously remove the grater with the micro-mesh
filter by grasping it at its rim and lifting it to the top.
Remove the juice container next.
• Disassemble the juice jug.
Remove the top cover of the juice jug then pull the foam separator out.
How to assemble your appliance
• Switch the appliance off.
Turn rotary knob to “OFF“ position and pull the mains plug!
• Attach the juice container.
Take the juice container and place it on the intended bulge on the base unit.
• Attach grater with micro-mesh filter.
Take the grater carefully at the rim of the micro-mesh filter and place the grater on the drive. Press against the
edge of the grater with both thumbs until the grater engages. You will hear a clear “click” when the parts engage.
Check the correct seat of the grater by turning!
To Next Page
Loading...