12. Technical Specification
Size: 18 x 8 x 5cm, cable 175cm long
Weight: 470g
Input: 100-240v AC 50/60Hz 0.25A
Output: 12v DC 1.25A 15W max
CE: Meets the requirements of BS EN 9001-2000
UK plug: 13 amp
13. Installation
1. Consider the following when choosing the location of your light source:
Access to a plug
The light source should be installed out of reach of clients
The light source is to be used in dry environments
If using a shelf or bracket check that these can comfortably hold the weight of the
unit
Fibre optic products are most visually effective in a darkened environment, not in
bright lighting conditions
2. Slide the boss of your fibre optics, Starcloth or Milky Way Carpet into the circular
hole in the front face of the light source. When using this with fibre optics, it may be
necessary to adjust the position of the boss in the port (i.e. not completely pushed in
as far as possible) to allow as many strands as possible to be illuminated.
3. Tighten the screw on the top of the unit to secure the fibre optics into the unit.
Please note: if you remove the cover from the light source you have to remove the
screw from the top which holds the fibre optics in.
4. Connect the power lead. If the fit does not seem tight, ‘wiggle’ the lead into the light
source, whilst pushing at the same time.
5. Using the ON/OFF rocker switch at the back of the light source, switch the light
source on.
Wi Fi compatibility
This unit is Wi Fi compatible, and therefore will respond wirelessly to the following products:
• 18870, 20402 - Talking Cubes
• 22871 Colour Command Centre™
• 19214 - Colour Changing Panel
• 19847, 21006 - 8 Colour Wirefree Controller
• 22716 ROMPA® Wi Fi Colour Control Bumpas – Set of 8
• 22867 Wireless Colour Controller Wall Mat
• 19939 – Wi Fi Interactive Carpet Switch Set
• 21917 – Wi Fi Microphone by ROMPA®
• 21918 Wi Fi Override Transmitter
• 20848, 21098 Sensory Magic Touch Screen
• 21728 ROMPA® Wi Fi App Control Box
When activated by a Wi Fi controller, the Rompa® Light Source will automatically change
colour to that selected for 1 minute, before resuming automatic mode.
To Next Page
Loading...