10
This allows you to adjust how the amplitude (volume) of the sound changes over time using an ADSR (Attack,
Decay, Sustain, and Release) envelope.
Attack
Attack Time. How quickly the amplitude envelope reaches the maximum value after pressing a key.
Decay
Decay Time. How quickly the amplitude envelope reaches the Sustain Level while a note is held down.
Sustain
Sustain Level. The amplitude level at which the sound will remain while a note is held down.
Release
Release Time. How quickly the envelope reaches minimum amplitude value after the note is released.
Perform the following steps to return your back to the default factory settings:
1. Turn the POWER button [A] to ON while holding down the BANK [1] button.
The MANUAL button should blink, indicating that the unit is ready to be reset. Simply turn the POWER button to
the OFF position if you choose to cancel the reset at this point, otherwise continue with step 2.
2. Press the MANUAL button to perform the factory reset.
3. When all buttons blink, switch the ’s power button to OFF, and then back to ON again.
The unit is now reset back to the default factory settings.
To Next Page
Loading...