CORDLESS SPRAY GUN
6
- Fill the viscosity cup with the diluted paint.
- Release your finger to let the paint leak and time it.
- Please refer to the thinning chart and picture.
Material Run out Time (Sec)
1) Oil enamel 25-60
2) Oil based primer 30-60
3) Oil stain No thinning required
4) Clear sealer No thinning required
5) Polyurethane No thinning required
6) Varnish 20-60
7) Lacquer sanding sealer 25-35
8) Lacqure 25-35
9) Automotive finishes 20-40
10) Latex 45-90
. CHOOSING THE PROPER NOZZLE
- The PORTABLE SPRAY GUN
can be equipped with1.0mm/1.8mm/2.5mm nozzle.
The spray nozzle sets are changeable with the M4 wrench,
simply turn the tip counterclockwise with the M4 wrench to
loosen.
- Place the desired nozzle tip on the gun head and then tighten
with M4 wrench.
- Fix the nozzle with air cap and big nut to complete the replacement.
Please refer to the nozzle size and recommended paint in the
table below.
Nozzle size Recommend material Project type
1.0mm Sealers and varnish Furniture and woodworking projects
1.8mm Stains and polyurethane Furniture and woodworking projects
2.5mm Latex paint, chalk type
paint, milk type paint
Furniture and cabinets
To Next Page
Loading...