CORDLESS SPRAY GUN
14
TROUBLESHOOTING
Problem Cause Solution
A. little or no material
flow
1.nozzle clogged
2.suction tube clogged
3.material volume setting
turn too far to the right
4.suction tube loose
5.material is too thick
6.inconsistent paint
7.container is loose
1.clean
2.clean
3.turn to the left
4.insert
5.check viscosity
6.strain paint
7.tighten the container
B. material leaking
1.nozzle loose
2.nozzle worn
3.nozzle seal worn
4.material build-up on spray
pattern dial and nozzle
1.tighten
2.replace
3.replace
4.clean
C. atomization is too
coarse
1.viscosity of material too high
2.material volume too large
3.nozzle clogged
4.too little pressure buildup
in container
1.thin
2.turn to the right
3.clean
4.tighten container
D. too much over
spray
1.gun too far from spray object
2.too much material applied
1.reduce distance
2.turn material volume
setting to right
E. pattern is very light
and splotchy
1.moving the spray gun too
fast
1.adjust material flow or
decrease movement of
spray gun
F. large cloud of paint 1. gun too close to surface
1.move gun away from
surface and reduce paint
flow
To Next Page
Loading...