USER MANUAL
13
STEP ONE: Clean up the gun
1) Unplug sprayer from electrical outlet and pull trigger on spray gun so
material inside unit flows back into the container.
2) Empty any remaining material from the container.
3) Fill container approximately 1/2 full with appropriate cleaning solution.
For latex, use warm soapy water; for oil-based, use a cleaning solution
recommended by the material manufacturer.
4) Plug sprayer into an electrical outlet.
5) Press the switch of the sprayer until the cleaning solution passes
through the spray nozzle for several seconds.
6) Remove container and properly discard the cleaning solution.
7) Unplug the sprayer from the electrical outlet.
STEP TWO: Clean up the nozzle tip
1) Unscrew the container and discard any remaining cleaning solution.
2) Remove the suction tube from the sprayer and clean it with warm,
soapy water.
3) Unscrew the air cap, remove the nozzle tips. Clean them with warm,
soapy water.
4) Let the components dry thoroughly and reassemble the unit.
5) Store the unit.
To Next Page
Loading...