RoomAndLoft Murphy - Page 6

K111
nut
K110
bolt
K160
Allen wrench
Top panel
Setting up the Bed Case – part B
Step 1: Open Box #2. Place the top panel on edge with the face molding toward the floor as shown. Gently roll the side panels up and slide the molding underneath, using guide
dowels to position the panels together. Use a K110 bolt and K111 barrel nut at each corner to connect the top panel to the sides as shown.
5
Roll up
Roll up
BUBBLE-PACK #2 CONTENTS
SHOWN ON PAGE 26
dowel