- 07 -
With a helper securely
holding the cabinet, pull the
bed out of the cabinet 4 to 5
inches. Working from
behind the cabinet,reattach
the bed stops.
Step 13:
If the room has existing base molding, make a
cut at the bottom rear of the cabinet verticals
to accommodate the existing base molding. If
room does not have base molding, simply
place cabinet flush against wall.
Step 14:
After assuring that the top and bottom of
the bed cabinet are against the wall,center
the face panel between the verticals by
placing a piece of folded cardboard
between the face panel and each of the
two verticals as illustrated.
Step 15:
FLOOR
SIDE VIEW
WALL
To Next Page
Loading...
