8
Jet E 130 / 170
SAFETY INSTRUCTIONS
Ÿ Make sure that the line cords are not damaged by running
over, pinching, dragging , etc.
Ÿ The machine must not be used unless the line cords are in
proper condition.
Ÿ When replacing coupler plugs of line cords or connecting
leads, splash-proof protection and mechanical strength must
be guaranteed.
Ÿ Protect the cable from heat, oil and sharp objects/edges.
Ÿ Unsuitable electrical extension cables can be hazardous. Only
use electrical extension cables outdoors which have been
approved and labeled for this purpose and have an adequate
cable cross - section.
Ÿ Do not operate the machine at low temperature and above
o
60 C.
Ÿ All current conducting materials in the working area must be
protected from jet cleaner.
- Do not clean the machine by means of vapour jet or
high pressure cleaning equipment. Do not allow
water to penetrate into the electrical parts.
-Do not operate the machine in or around an explosive
environment.
DO NOT USE THE MACHINE DIRECTED AT THE
PERSONS, ANIMALS, LIVE ELECTRICAL EQUIPMENT
OR THE MACHINE ITSELF.
- Only qualified personnel must perform any work related to
maintenance and repair on the machine
- Turn the machine off before cleaning and maintenance, while
replacing parts.
Transport
In order for easy transportation of the machine, it is
recommended to tip the machine as shown in the figure.
To Next Page
Loading...