33
RootsScrub E4550 ES
Maintenance Work
Com pliance wit h our reco mmen dat ions co ncer ning
maintenance work will give you the certitude always having a
machine at your disposal, which is ready to work and in good
operating condition.
Please contact your local Roots Multiclean Ltd. distributor; the
people there will be glad to perform that work for you. There well
trained personnel and genuine Roots spare parts are at your
disposal.
l Well trained personnel and genuine Roots spare parts are at
your disposal.
l In case of any inquiries or orders for spare parts, please
always quote the machine's serial number mentioned on the
nameplate.
l The name plate is fixed in the rear side of the machine.
l When cleaning or servicing the machine, and when replacing
any parts, shut off the machine and on principle disconnect
the power plug from the power supply.
l For reasons of safety during cleaning and/or maintenance
work in or on the tank, the tank lid - when lifted - must be
secured so as to prevent accidental closing or tilting down.
l The machine may be taken into operation only if all guarding
devices are fitted and in protective position. As far as
possible, cleaning should not be done by hand, but using
appropriate tools or equipment.
l Maintenance and repair work may be carried out only by
means of suitable tools and by the people trained in the
factory. For reasons of safety, only genuine Roots spare parts
may be used.
Post-scrubbing Checkpoints
= Check the tank lid seals for damage and wear.
= Clean the float.
= Check the condition of the brushes. Remove any string, rope or
other debris wrapped around them.
= Check the vacuum hose for block/damage.
= Check if both the tanks are completely clean.
= Check the machine exteriors for any damages or dirt.
MAINTENANCE
To Next Page
Loading...