Roper Automatic washers - Using Rinse and Spin (Cycle Control Knob); Additional Rinse and Spin; Using Drain and Spin (Cycle Control Knob); Drain and Spin Procedure

12
Using rinse and spin
(models with Water
Temperature Selector
in Cycle Control Knob)
When using extra detergent for heavily-
soiled clothes, or washing special-care
items, you may find an extra rinse and spin
is needed.
1. For an additional rinse, push in the Cycle
Control Knob and turn it clockwise to
RINSE, as shown.
2. Pull out the Cycle Control Knob. The
washer fills, agitates, drains, and spins.
Using drain and spin
(models with Water
Temperature Selector
in Cycle Control Knob)
A drain and spin may help shorten drying
times for some heavy fabrics or special-care
items by removing excess water.
1. Push in the Cycle Control Knob and turn
it clockwise to SPIN, as shown.
2. Pull out the Cycle Control Knob. The
washer drains, then spins.
Stopping/restarting your washer
• To stop the washer at any time, push in
the Cycle Control Knob.
• To restart the washer, close the lid (if
necessary) and pull out the Cycle
Control Knob.
SPIN
SPIN
SPIN
OFF
OFF
OFF
NORMAL
PERMANENT
PRESS
RINSE
RINSE
RINSE
RINSE
RINSE
RINSE
SPIN
OFF
SPIN
OFF
SPIN
OFF
NORMAL
PERMANENT
PRESS
OPERATING YOUR WASHER