To Next PageTo Next Page
Need help?Do you have a question about the Ropex RESISTRON RES-5009 and is the answer not in the manual?
General| Brand | Ropex |
|---|---|
| Model | RESISTRON RES-5009 |
| Category | Controller |
| Language | English |
Explains how to use the manual for installation, startup, operation, troubleshooting, and maintenance.
States that drawings and illustrations are exemplary and simplified for clarity.
Details signal words and their importance in warning notices for safe operation.
Provides crucial safety regulations, warnings, and information for safe operation.
Defines the qualifications required for personnel operating the controller.
Specifies requirements for the heating element, including temperature coefficient.
Explains the necessity and specifications for using ROPEX line filters for EMC compliance.
Describes the RESISTRON® Temperature Controller's application in film sealing processes.
Lists key features like AUTOCAL, AUTOTUNE, AUTORANGE, and diagnostic capabilities.
Instructions for checking delivery completeness and visual inspection for damage.
Step-by-step guide for mounting and installing the RESISTRON® Temperature Controller.
Details electrical connections, including line, overcurrent protection, contactors, and transformers.
Illustrates the standard wiring connections for the RESISTRON® Temperature Controller.
Identifies and explains the various components and indicators on the RESISTRON® controller.
Covers settings for voltage/current ranges, coding switch, and alarm relay.
Guides through the initial startup process, including voltage checks and calibration.
Explains the LEDs and their meanings for status indication.
Describes data transmitted from the master to the controller, including setpoints and commands.
Covers configurable parameters like temperature range, alloy, and monitoring thresholds.
Lists and explains error numbers, causes, and remedies for troubleshooting.
How to set the CAN baud rate based on the CANopen network.
Procedure for assigning a unique node address to each CANopen device.
Lists and describes standard CANopen objects supported by the controller.
Details CANopen objects for parameters like temperature, alloy, and monitoring.
How to set the CAN baud rate using DIP switches for ROPEX CAN.
Procedure for setting the CAN identifier using DIP switches.
Command range for receiving CAN messages, including setpoint commands.
Command range for sending CAN messages, including status and actual value queries.
