ROSCAMAT MOSQUITO - User Manual

Questions and Answers

H
Heidi BrownAug 2, 2025
What to do if my ROSCAMAT Tape Deck clutch slips and the tap cannot be turned?
- P
  parkersusanAug 3, 2025
  If the clutch slips and the tap cannot be turned, there are several potential causes. It could be due to clutch slackness, which requires a clutch adjustment. Lack of tool lubrication is another possibility, so ensure you are using cutting oil. The issue might also stem from using an inappropriate tap for the material; use the correct tap according to the material and manufacturer’s advice. Other potential causes are: tap spoiled or worn; misaligned hole; drilled hole diameter too small.
I
Ivan BrownAug 10, 2025
Why is the ROSCAMAT Tape Deck lubrication system failing to operate?
- K
  Kimberly WatkinsAug 10, 2025
  If the lubrication system fails to operate, it could be due to an empty oil reservoir, in which case you should fill the reservoir. Another possible cause is a clogged oil-hole. To resolve this, unscrew the end of the lubrication nipple and clean it, but be careful not to misplace the spring and the ball located inside.
N
Nicole GreenAug 17, 2025
What to do if my ROSCAMAT Tape Deck machine fails to operate, the motor does not start or stops?
- J
  Jason VangAug 17, 2025
  If the ROSCAMAT Tape Deck machine fails to operate, and the motor doesn't start or stops, you must reset the machine and restart the system. Switch the machine off and on. If the problem is due to external voltage or current issues, wait until it stabilizes. If the problem persists, further assistance may be needed.
J
Jonathan Rodriguez Jr.Aug 25, 2025
How to fix a ROSCAMAT MOSQUITO Tape Deck tilting arm that drops?
- N
  Nathan FowlerAug 25, 2025
  If the tilting arm drops, it could be due to a not-equilibrated arm. In this case, balance the arm according to the weight to be held. Another possible cause is a defective damper, which would need to be replaced with a new one.