1) Open accessory slot (Iris Slot) on fixture.
2 ) Slide Vo rt ex 360 into fixture’s accessory slot with m o t o r
covering facing toward the front of the fixture . (This is
i m p o rtant to avoid overheating the motor and to keep the
shutters readily accessible.)
3) Use safety cable through handle of Vortex 360 to attach to
fixed safety point.
4) Make sure power adapter cable is not touching any part of
the fixture.
I N S TALLING THE VORTEX 360 IN THE FIXTURE
4
Glass gobo placed into Vortex 360.
Vortex 360 being installed
in a fixture (re q u i red safety
cable not shown).
To Next Page
Loading...