Nemo Gateway 15
See “Configuration Interface” for additional information.
Configuration Interface
See “Accessing Configuration Interface” to launch the Configuration Interface.
Security
To prevent unintentional changes, you may enable “Password Mode”. This
option can be found in the System Settings > Security section and will enable
the requirement to enter a user name and password prior to adjusting any
settings.
When enabling the “Password Mode”, you must provide the user name and
password you wish to use.
To reset the credentials please see “Reset” in “Troubleshooting”.
NOTE: The Nemo Gateway does not provide secure data transmission,
secure firmware updates, or encrypted storage of settings and information.
It is required for the user to maintain physical security of the Ethernet
network to which the Nemo Gateway is connected.
Firmware
Firmware information is available in the System Settings > Firmware section of
the app. If an update is available there will be a notice on the top of the main
view.
The version currently installed on the Gateway will be displayed, as well as if an
update is available.
“Firmware Update Available” and an Update Now button is displayed on the
Firmware view when the firmware is out of date. Select the Update Now button
to install the latest version of firmware. The new firmware will then download,
install, and the gateway will reboot.
The “Branch” section allows the user to select what version of firmware will be
downloaded. This option should be left on Default unless otherwise instructed
by Rose Point Navigation Systems.
To Next Page
Loading...