Nemo Gateway 17
Priorities may be set for each class (e.g. Position, Speed, Depth, etc.) of data. By
default, the priorities are chosen by the order the devices are discovered; the
first – highest priority, the last – lowest priority. To change the priority, select
Sensors > Sensor Class > Edit button, and drag the three-bar-icon up and down
to rearrange the order (top - highest, bottom – lowest).
Individual sensors can also be enabled/disabled in this menu.
Advanced Port Output
Please refer to our Nemo Gateway Configuration Guide online for the most
current configuration walkthroughs. The device’s configuration interface is
subject to change without notice.
Each port that is capable of outputting data will have a “Talker Options” section.
Repeating Data
The UDP and NMEA 0183 ports can repeat data received on other ports of the
same data format (NMEA 0183). Each source may be toggled On/Off
individually.
To configure data repetition options:
Port (UDP/NMEA 0183) > Talker Options > Repeating > Edit
Note: When possible, the Nemo Gateway should be set up to generate all
outgoing data. The ability to repeat data being received from other NMEA 0183
ports is designed to output sentences that the Nemo Gateway cannot parse or
generate on its own.
Generating Data
Ports can generate data (translate) from sources of other data formats. Data
generation may operate in auto (default), or manual mode.
Auto Mode
To Next Page
Loading...