WARNING
LEAK TESTING
All gas connections must be properly leak tested at installation.
WARNING
PRECAUTIONARY SIGNS
Observe and comply with all precautionary signs posted on the GC. Failure to do so may result in injury or death to personnel or
cause damage to the equipment.
WARNING
VENTILATION
If you plan to place the GC in a sealed shelter, always vent the GC to atmosphere with ¼-in. tubing or larger. This will prevent the
build up of H
2
and sample gas
WARNING
TOXIC VAPORS
Exit ports may discharge dangerous levels of toxic vapors.
Use proper protection and a suitable exhaust device.
WARNING
BURN HAZARD
Some parts of the analyzer may be heated to 120 °C (248 °F).
To prevent burns, do not touch any of the hot parts. All parts of an analyzer are always hot unless it has been switched off and
allowed to cool down.
Before fitting, removing, or performing any maintenance on the analyzer, make sure that it ha been switched off and allowed
to cool for at least two hours.
When handling the analyzer, always use suitable protective gloves.
These precautions are particularly important when working at heights.
If burned, seek medical treatment immediately.
Failure to observe this warning could cause an explosion or potentially hazardous situation, which if not avoided, may cause
personal injury or death.
CAUTION
REPLACEABLE PARTS
No user replaceable parts inside except a few parts which are only to be accessed by trained service personnel. All replacement
parts must be authorized by Rosemount to ensure product certification compliance.
WARNING
Physical access
Unauthorized personnel may potentially cause significant damage to and/or misconfiguration of end users’ equipment. This could
be intentional or unintentional and needs to be protected against.
Physical security is an important part of any security program and fundamental to protecting your system. Restrict physical access
by unauthorized personnel to protect end users’ assets. This is true for all systems used within the facility.
4
To Next Page
Loading...