1 Getting started
Emerson started and inspected your gas chromatograph (GC) before it left the factory.
Emerson also installed program parameters and documented them in the GC Config
Report furnished with your GC.
1.1 Select site
The site you select for the gas chromatograph (GC) is important for measurement
accuracy.
Procedure
Install the GC as close as possible to the sample system, but allow for adequate access
space for maintenance tasks and adjustments.
WARNING
HAZARDOUS AREA EXPLOSION HAZARD
Failure to follow this warning may result in injury or death to personnel.
Do not use a personal computer (PC) or printer in a hazardous area.
Emerson provides serial and Ethernet communication links to connect the analyzer to
the PC and to connect to other computers and printers in a safe area.
Allow a minimum of 3 ft. (0.9 m) in front of the GC for operator access. Ensure that
exposure to radio frequency interference (RFI) is minimal.
1.2 Unpack the gas chromatograph (GC)
Unpack and inspect the Rosemount 700XA gas chromatograph upon receipt.
WARNING
LIFTING HAZARD
The Rosemount 700XA is heavy equipment. Failure to observe this warning may cause
serious injury to personnel.
Use two people to move the GC.
Observe all proper lifting methods as defined by your site operating procedures.
Procedure
1. Unpack the equipment.
a) Remove the Rosemount 700XA from the shipping crate.
b) Remove the USB memory stick containing the software, applications, Quick
Start Guide, and manuals.
Quick Start Guide Getting started
00825-0100-3770 July 2020
Rosemount 700XA 9
To Next Page
Loading...