Page 4
Precautions
1 This unit should be installed by a qualified service techni-
cian.
2 This product is designed to operate with a 12-Volt,
negative ground battery.
3 Disconnect the ground wire from the battery terminal
before connecting this unit to the electrical system.
4 Other products or accessories may have wires that are
color-coded similarly to those for this unit. Refer to the
electrical diagrams of any other products before installa-
tion of the unit to avoid making wrong connections.
5 To avoid short-circuiting the electrical system, use proper
insulation and fastening materials.
6 Do not connect the units yellow wire directly to the
battery terminal. Connect the units red wire to the ACC of
the ignition switch. Failure to connect the red and yellow
wires properly may drain the vehicles battery.
7 To avoid damaging the unit, use only the accessories
supplied with the unit.
8 Do not install this product at an angle exceeding ±30°.
9 Do not install this product in a position that may cause
injury to passenger(s) during an accident.
2 Installing the DA-7169 Monitor
To Next Page
Loading...
