2. Before fi rst time use
The spring must be fi tted. The spring is provided as a separate component.
To position the spring remove the retention nut (No. 2 Illustration 1) from the
punch and pull out the cutting unit. Position the spring in the tube and refi t
the punch. Tighten the nut.
(Figure shows fi tting of the cherry punch)
The pitter is now ready for use.
ROE-Anleitung-Entkerner.indd 17ROE-Anleitung-Entkerner.indd 17 25.01.2011 16:01:17 Uhr25.01.2011 16:01:17 Uhr
To Next Page
Loading...
