41
English
Lighting the side burners (G3, G4)
1. Insert the AA battery, 1.5 V, in the electronic igniter 12.
2. Open the side burner lid before lighting the side burner.
3. Before starting the lighting procedure, the control knob must be set to the position "OFF".
4. Open the valve at the gas cylinder if you have not already done so.
5. Press the control knob 19 inwards and turn it anti-clockwise to the position "MAX".
6. Press igniter 12 to also light the side burner.
7. If the burner does not light immediately, turn the control knob back to "OFF", wait 1 minute to allow
the accumulated gas to disperse and then repeat the lighting procedure.
8. In exceptional cases, use a match to light the burner if the igniter does not produce a spark.
9. You can now use the control knob to adjust the ame to suit your particular requirements. For the lo-
west setting, you turn the control anti-clockwise to "MIN".
10. If you do not succeed in lighting the grill, refer to the section headed "Troubleshooting" on page 50.
Primezone (Pro G3, Pro G4)
The Primezone with an infrared gas burner is ideal for ash frying, e.g. steaks, in order to obtain a crispy
texture at approx. 800°C surface temperature .
The gas grill should be positioned so that the Primezone is sheltered from the wind where possible
as strong winds may effect its performance.
Never use the grate of the Primezone as a tray for grilled food. Liquids and fat drop into the cera-
mics and clog them. This will lead to a malfunction.
Never bend over the open grill. Always keep at least 30 cm away from the igniter opening when
lighting the Primezone.
The infrared gas burner generates very intensive heat. Do not leave grilled food on the burner unat-
tended as it may burn quickly. The lid must never be closed when using the infrared burner at a high
ame. This allows better monitoring of the grilled food in order to avoid burning.
Using / Starting up the Primezone in the side table
1. Open the lid of the Primezone before lighting it.
2. The Primezone has a grate which can be used at two different heights.
• The upper position can be used like a normal gas cooker and is suitable for preparing sauces, soups, etc.
The recommended diameter for pots and pans is 25 to 30 cm.
• The lower position is ideal for frying meat. Please insert accordingly before lighting the Primezone.
Upper position Lower position
The lid of the Primezone can only be closed when the grate is in the lower position.
3. Turn on the valve on the gas cylinder.
4. Press the control knob 20 inwards and turn it anti-clockwise to the position "MAX".
5. Now light the Primezone by pressing the electronic igniter 12. Keep the igniter pressed until the burner
lights up.
6. Use a match to light the burner if the igniter does not produce a spark.
• For the lowest setting, you turn the control anti-clockwise to "MIN".
To Next Page
Loading...
Need help?
General
