Document Information
• Ross Part Number: 4802DR-120-13.0
• Release Date: March, 2018. Printed in Canada
• Equipment: This document applies to the Carbonite
(4802AR-200-xx), Carbonite MultiMedia
(4802AR-201-xx), and Carbonite+ (4802AR-202-xx)
frames.
Copyright
©
2018 Ross Video Limited, Ross
®
, CrossOver
®
,
MiniME
™
, and any related marks are trademarks or
registered trademarks of Ross Video Limited. All other
trademarks are the property of their respective companies.
PATENTS ISSUED and PENDING. All rights reserved.
No part of this publication may be reproduced, stored in
a retrieval system, or transmitted in any form or by any
means, mechanical, photocopying, recording or
otherwise, without the prior written permission of Ross
Video. While every precaution has been taken in the
preparation of this document, Ross Video assumes no
responsibility for errors or omissions. Neither is any
liability assumed for damages resulting from the use of
the information contained herein.
Microsoft
®
, Windows
®
, and Windows XP
®
are either
registered trademarks or trademarks of Microsoft
Corporation in the United States and/or other countries.
Patents
Patent numbers US 7,034,886; US 7,508,455; US
7,602,446; US 7,802,802 B2; US 7,834,886; US
7,914,332; US 8,307,284; US 8,407,374 B2; US
8,499,019 B2; US 8,519,949 B2; US 8,743,292 B2; US
D752,530 S; GB 2,419,119 B; GB 2,447,380 B; and other
patents pending.
Important Regulatory and Safety
Notices to Service Personnel
Before using this product and any associated equipment,
refer to the “Important Safety Instructions” listed in
the front of this manual to avoid personnel injury and to
prevent product damage.
Product may require specic equipment, and/or
installation procedures to be carried out to satisfy certain
regulatory compliance requirements. Notices have been
included in this publication to call attention to these
specic requirements.
Symbol Meanings
Protective Earth: This symbol identifies a Protective
Earth (PE) terminal, which is provided for connection
of the supply system's protective earth (green or
green/yellow) conductor.
Important: This symbol on the equipment refers you
to important operating and maintenance (servicing)
instructions within the Product Manual Documentation.
Failure to heed this information may present a major
risk of damage or injury to persons or equipment.
Warning: The symbol with the word “Warning” within
the equipment manual indicates a potentially
hazardous situation which, if not avoided, could result
in death or serious injury.
Caution: The symbol with the word “Caution” within
the equipment manual indicates a potentially
hazardous situation which, if not avoided, may result
in minor or moderate injury. It may also be used to
alert against unsafe practices.
Warning Hazardous Voltages: This symbol is
intended to alert the user to the presence of
uninsulated “dangerous voltage” within the product
enclosure that may be of sufficient magnitude to
constitute a risk of shock to persons.
ESD Susceptibility: This symbol is used to alert the
user that an electrical or electronic device or assembly
is susceptible to damage from an ESD event.
Important Safety Instructions
1.
Warning: Read these instructions.
2.
Keep these instructions.
3.
Heed all warnings.
4.
Follow all instructions.
5.
Do not use this apparatus near water.
6.
Clean only with a dry cloth.
7.
Do not block any ventilation openings. Install in
accordance with manufacturer's instructions.
8.
Do not install near heat sources such as radiators,
heat registers, stoves, or other apparatus (including
ampliers) that produce heat.
9.
Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding
type plug has two blades and a third grounding
prong. The third prong is provided for your safety.
If the provided plug does not t into your outlet,
consult an electrician for replacement of the obsolete
outlet.
Carbonite Setup Manual (v13.0) — Document Information • 3
To Next Page
Loading...
