© 2012 Ross Video Limited. All rights reserved. Contents of this publication may not be reproduced in any form without the written permission of Ross Video Limited.
Printed in Canada.
2
6. Insert the new NK-O3G72 output card in the front of the frame so that the BNCs protrude through the openings in the frame and
so that the card is fully inserted into the card edge connector.
7. Tighten the two mounting screws that hold the new NK-O3G72 output card in the frame.
8. Connect the cables to the new NK-O3G72 output card.
9. Power up the NK-3G72 router.
10. Verify the functionality of the router.
If there any issues, contact Ross Video Tech Support.
11. Return the old NK-O3G72 output card to Ross Video.
Upgrading the NK-3G72 Software
In Phoenix, right-click the necessary NK-3G72 frame in the IPS Explorer window and select Send New Firmware (see the image
NK-3G72 in Phoenix below).
The current SW version number is shown in the Device Properties window (see the image NK-3G72 in Phoenix below).
NK-3G72 in Phoenix
Contact Ross Video Tech Support to obtain the latest version of the software.
Card Edge ConnectorBNC Opening
Software Version
To Previous Page
Loading...
