What to do if NK-VRC Ross NK Network Hardware is not responding to DashBoard?
If the NK-VRC is not responding, it may be due to corrupted information stored within the unit. To resolve this, try resetting the NK-VRC or sending the default configuration to the NK-VRC until it responds.
Why does NK-VRC Ross NK take a long time to start up?
A long startup time for the NK-VRC can occur if the mapping table contains non-existent crosspoints. The solution is to remove table entries that do not correspond to physical connections on the routing switchers.
General| Category | Network Hardware |
|---|---|
| Type | Video Router |
| Video Standards | SDI |
| Control Protocol | RossTalk, SNMP |
| Power Supply | Redundant power supplies available |
| Dimensions | 4RU |
| Inputs | Depending on the model: SDI, IP, Fiber |
| Outputs | Depending on the model: SDI, IP, Fiber |
Details copyright, patents, disclaimers, and general notices for the document.
Covers safety warnings, regulatory compliance, and EMC specifications.
Outlines product warranty, environmental policy, and company contact information.
Introduces the guide, its conventions, and provides technical support contact details.
Lists NK-VRC features, typical system components, and a general system overview.
Outlines planning steps, communication flow, and data storage within the system.
Explains how resources route signals between different router types and manage tie lines.
Covers equipment checks, hardware overview, and physical installation into a rack frame.
Guides on connecting power, checking software versions, and performing software upgrades.
Lists prerequisites and guides on accessing the NK-VRC interface via DashBoard and NK-IPS.
Explains sending configurations, SmartPaste, virtual routing, labeling, and mapping tools.
Details setting up resources, resource rules, and control panel/device priorities.
Covers compatibility settings, log setup, machine control, and saving configurations.
Demonstrates resource management setup for a single router system with up-converters.
Illustrates resource management setup for a system involving two routers and audio converters.
Provides operational context and explains front panel LED functions for monitoring.
Explains how priorities affect resource access and how to monitor resource usage.
Provides methods for resetting the NK-VRC to a known operating state, including the reset button.
To Next Page
