NK-VRC User Guide (v05) Setting Up the NK-VRC • 21
Name – this field can be assigned by the user to uniquely name a device.
This field has a maximum of 16 characters and is used for description and identification only.
Group – a group number can be assigned by the user to organize devices into groups. For example, users can assign
separate group numbers for devices in different physical areas.
This field has a maximum of 10 characters, and by default is blank.
Details – assigned by the user to give a device specific details. For example, a physical location or a brief
description of its use.
This field has a maximum of 16 characters and is used for description and identification only.
Address – the address is used within the overall control system to identify devices. Each device must be given a
unique T-Bus address to avoid hardware and communication conflicts.
The valid value range for assigning an individual device T-Bus address is 1-255. The default is 253.
Other Functions
Refresh – click this button to revert to the configuration previously sent to the device. Any changes in the interface
are discarded and the configuration is reloaded from the device.
Send Firmware – click this button to open a file browser to select a software file to send to the device.
Send Configuration – click this button to upload the configuration to the device. All configuration items take
effect only after uploading.
Reboot – click this button to reset the device.
Close – click this button to close the NK-VRC interface.
Sending the Configuration to a Device
When changes have been made to the configuration of an NK-VRC, the changes are not activated until the
configuration is sent to the device. Saved configuration files can be opened, have changes made to the
configuration, saved, and then be sent to a device.
To send the current configuration to the NK-VRC
1. Open or select a interface for an NK-VRC.
2. Configure the NK-VRC. Save the configuration to a configuration file if necessary.
3. Click
Send Configuration.
The Send Config to NK Device window opens.
Any of the pages in the NK-VRC interface containing information that has been changed are automatically
selected for sending to the NK-VRC except the Physical Map, which does not register as changed.
To Next Page
Loading...
