NK-VRC User Guide (v05) Setting Up the NK-VRC • 19
Setting Up the NK-VRC
DashBoard is used to configure and operate NK systems and individual NK Series devices including the NK-VRC.
The DashBoard client software and manual can be downloaded from our website.
You need an NK-IPS connected to the system to configure the NK-VRC via DashBoard.
For More Information on...
• on checking software, see “Checking the Software Version of the NK-VRC” on page 17.
• on upgrading software, see “Upgrading the NK-VRC Software” on page 18.
• DashBoard system requirements and installation, refer to the DashBoard User Guide.
Before You Begin
An NK-IPS network bridge must be connected to the system. Use the NK-VRC interface in DashBoard to configure
the NK-VRC.
Before setting up any parameters for the NK-VRC, ensure that all NK Series devices in the routing switcher
system have software v2.00 or later.
Accessing the NK-VRC Interface in DashBoard
The NK-VRC displays in the DashBoard Tree View as a sub-node of the NK-IPS or NK-NET that the NK-VRC is
physically connected to. The NK-VRC interface is organized into three panes: Device Details, Configuration, and
Device Control.
For More Information on...
• downloading and installing the DashBoard client software, refer to the DashBoard User Guide.
To access the NK-VRC interfaces in DashBoard
1. Locate the NK-VRC in the Tree View of DashBoard.
2. Double-click the NK-VRC node for the NK-VRC that you want to configure.
The NK-VRC interface opens in the right-side of the DashBoard window.
To Next Page
Loading...
