19
Storage
Never put a chain saw into storage for longer than 30 days without carrying out the following
steps.
• Remove the fuel tank cap slowly to release any pressure in tank.
• Carefully drain the fuel tank.
• Start the engine and let it run until the unit stops to remove fuel from carburettor.
• Allow the engine to cool (approx. 5 minutes).
Maintenance Cont …...
Returning the saw back into operation
• Remove spark plug.
• Clean the spark plug and check that the electrode gap is correct.
• Fill fuel tank with proper fuel / oil mixture.
• Fill the chain oil tank.
See Fuel and Lubrication Section.
TROUBLE SHOOTING
WARNING: During normal operation the chain brake, clutch cover, bar and chain
are lubricated with chain oil. After use oil will drain for many weeks and pool on the
surface underneath the chainsaw.
Place the chainsaw on a protected surface to contain the draining lubricating oil
when not being used.
To Next Page
Loading...
