Your EZ-SERV® Standing Dispenser comes with the 6-Wing 1 Tbsp Portion Wheel. This
portion wheel is perfect for dispensing items such as medium grind cookies, cereals &
granolas, trail mixes and coffee beans!
SETTING UP YOUR PRODUCT
1. Carefully remove all parts from packaging and poly bags:
• 1 Table Stand
•
1 Wooden Tray
•
Depending on your model, 1-5 Containers each one with:
a. Lid
b. 6-Wing 1 Oz Portion Wheel
c. Container
d. Label Holder
e. Handle
2. Make sure you have all parts above before discarding packaging.
3.
4.
5.
Repeat Steps 5 thru 8 for the remaining containers.
Attach label holder (d) to bracket as shown in FIGURE A
.
6.
7.
8.
9.
10.
Dispense as you please!
EZ-SERV® TABLE-TOP DISPENSER WITH WOOD TRAY
FIGURE A
Please contact customer support at (847)763-1215 and we’ll be
happy to assist with any assembly questions, comments or concerns.
ROSSETO
®
3600 W. Pratt Avenue. Lincolnwood, IL 60712
Visit our website at: www.rosseto.com
NEED ASSISTANCE?
6-WING 1 OZ PORTION WHEEL
ITEM # EZP004
FULL CONTAINER (with LID)
ITEM # EZC014S
LABEL HOLDER
ITEM # EZM036
HANDLE
ITEM # EZH012
1.
Hold Label Holder horizontally beneath the bracket., above the steel handle.
2.
Slide the label holder forward into the slot alloted. There are 2 small wings on the back
portion that will glide over
the metal until you can lock it into position.
3.
Hold the bottom portion of the label holder
and pull gently until it clicks into
place.
4.
Insert
the desired label.
b
c
d
e
a
Place table stand on a flat surface facing you.
Find the ridges on the underside of the wooden tray – these mark the back of the tray. Place the wooden tray on the base
of the table stand, with the smoother side of the tray facing you.
Fill containers with desired dry product and seal with the lid. (You may also choose to do this after Step 7.)
Hold the container above the stand with the handle facing you. Carefully lower the container down to the metal opening,
tilted at an angle that allows the handle to clear through first.
Note: The back of the container has a small key that aligns with bracket notch to prevent movement from side to side.
Once the handle is cleared through the metal opening, you may tilt the container carefully back to a full upright
position. Then, gently set the container down directly on the stand.
NOTE:
Recommended label size is 60 x 35 mm / 2.35" x 1.4"
1 2 3
To Next Page
Need help?
General
