Rotary MCH418 - User Manual

Questions and Answers

S
Steven SchultzAug 14, 2025
What to do if Rotary Lifting columns show Emergency Stop?
- W
  William SmithAug 15, 2025
  To restore operation of your Rotary Lifting columns, clear the emergency stop button at the indicated column.
T
tamarablankenshipAug 18, 2025
What to do if Rotary MCH418 Lifting columns display a Communication Error?
- T
  Tami BlackburnAug 18, 2025
  First, check for any loosened or unhooked communication cables and reattach if necessary. Then press “x” to clear the error. Also, verify that all columns are powered on. If one column has been powered down, power down the other columns to re-initialize the system.
J
Joanna GarciaAug 21, 2025
What to do if Rotary MCH418 Lifting columns detect a Short circuit?
- B
  Brianna JamesAug 21, 2025
  Press “x” to clear the error. To find the faulty component in your Rotary Lifting columns, run the column by itself and follow these steps until the error reappears: 1) While not operating (Error? Check/replace contactor) 2) Up button (Error? Check/replace contactor) 3) Slow lower (Error? Check/replace small lowering valve) 4) Lower to locks (Error? Check/replace large lowering valve) 5) Down button (Error? Check/replace lock solenoid.
C
cindyturnerAug 25, 2025
What to do if Rotary Lifting columns are Out of Level?
- M
  Miguel WatsonAug 26, 2025
  Press “x” to clear the error. Then, individually adjust each Rotary Lifting column back to a level position. Once all columns are level, they can be moved as a group.
M
Melissa KennedyAug 28, 2025
What to do if Rotary Lifting columns display is Unresponsive?
- B
  bharrisAug 28, 2025
  Turn off the power to your Rotary Lifting columns. Check the wire connections on the display board for the keypad, pushbuttons, and control board. Restart the power and test the display.
E
Emily LopezAug 31, 2025
What to do if Rotary MCH418 Lifting columns have Improper configuration?
- A
  Audrey EvansAug 31, 2025
  Press “x” to clear the error on your Rotary Lifting columns. To add the column to the system, first power down the column, and then unlock the system. Power up the column, assign a position, then re-lock the system.
T
Thomas ChavezSep 4, 2025
Why are my Rotary Lifting columns Slow To Rise?
- S
  Shari RodriguezSep 4, 2025
  Your Rotary Lifting columns might be slow to rise due to being overloaded, or there might be an issue with the battery and connections, or dirt/debris in the oil system. Check these potential causes.
K
Kelly RamosSep 7, 2025
What to do if Rotary Lifting columns show a Software mismatch?
- S
  Sharon GonzalezSep 7, 2025
  Power down and disconnect the affected Rotary Lifting column from the system. Load the column with the newest software code. To check the software revision level, insert a service card. The revision level is indicated in the service menus as “r__.”
V
Victoria RobinsonSep 10, 2025
What to do if Rotary Lifting columns show a CPU error?
- M
  Marc AndersonSep 12, 2025
  Press “x” to clear the CPU error on your Rotary Lifting columns. If the problem continues, call for service.